Unitech MS836

Reread Same Barcode with No Delay: The scanner is
allowed to reread same barcode, ignoring the
Reread Same Barcode with a Delay: The scanner is
not allowed to reread same barcode before the reread
delay expires.
To disable rereads of same barcode, enable the
Reread Same Barcode with a Delay and set the delay
to 0.
W100A00
*Reread Same Barcode
with No Delay
W100A10
Reread Same Barcode
with a Delay
Example: Set the reread delay to 5s
1. Scan the Enter Setup barcode.
2. Scan the Reread Delay barcode.
3. S c a n t h e num e ri c b a r c od e s “ 5 ” a n d “ 0 ”.
(See the Digit Barcodes section in Appendix)
4. Scan the Save barcode. (See the Save/Cancel
Barcodes section in Appendix)
5. Scan the Exit Setup barcode.