Unitech MS836

Appendix
Factory Defaults Table
Parameter
Factory
Default
Remark
System Settings
Barcode Programming
Enabled
Programming Barcode Data
Do not send
Scan Mode
Manual M
ode
Manual
Mode
Decode Session Timeout
15 s
1 -255s; 0: infinite.
Continuous Mode
Decode Session Timeout
15 s
1 -255s; 0: infinite.
Timeout between Decodes
1.0s
0 .0 -25.5s
Reread Same Barcode
With no delay
To disable rereads of same
barcode,
enable the
Reread
Same Barcode with a Delay
and set the delay to 0.
Sense Mode
Decode Session
Timeout
15 s
1 -255s; 0: infinite.
Image Stabilization Timeou
t
0.4s
0 .0 -25.5s
Reread Same Barcode
With no delay
To disable rereads of same
barcode,
enable theReread
Same Barcode with a Delay
and
set the delay to 0.
Sensitivity
Medium
Command rigger Mode
Decode Session Timeout
15
s
1 -255s; 0: infinite.
ecurity Level
0
Good Read Beep
Enabled
Good Read Beep Frequency
Medium
Good Read Beep Duration
80ms
Decode Result Notification
Disabled
Silent Mode
Disabled
Temporary setting
Illumination
On When Scanning
Temporary setting