You can also connect the MS842P scanner optionally to another dongle by
following the steps made below.
1. Scan the Disconnection
barcode.
2. Insert another dongle into a
USB port of the computer or
laptop PC.
3. Scan the MAC address of
the dongle by using the
MS842P scanner.
4. When being successfully
connected to the dongle, the
scanner will beep shortly one
time with a high tone.
6
Copyright 2013 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
To Next Page
Loading...
