Unitech MS842P - Low Power Mode; Time Delay to Low Power Mode

36
Copyright 2013 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.
Auto Aim
Low Power Mode
This parameter determines whether or not the digital scanner enters low power
mode after a decode attempt. If disabled, power remains on after each decode
attempt.
Time Delay to Low Power Mode
This parameter sets the time the decoder remains active after decoding. After a
scan session, the decoder waits this amount of time before entering Low Power
Mode.
Note: This parameter only applies when Power Mode is set to Low.