Unitech MS852B Plus - Page 108

-92- © 2020 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS852B Plus User’s Manual
3.2.10 UPC-A
Code UPC-A On*
Default All UPC-A Settings
Code UPC-A Off
Note: To convert UPC-A bar codes to EAN-13, see Convert UPC-A to EAN-13..
3.2.10.1 UPC-A Check Digit
This selection allows you to specify whether the check digit should be
transmitted at the end of the scanned data or not. Default = On.
On*
Off
3.2.10.2 UPC-A Number System
The numeric system digit of a U.P.C. symbol is normally transmitted at the
beginning of the scanned data, but the unit can be programmed so it will not
transmit it. Default = On.
On*
Off