9
First Steps with PA500
Perform the following easy installation steps to start using your device:
1 Install the battery pack
WARNING! There is a risk of fire and burns if the battery pack is
handled improperly. DO NOT disassemble, crush, puncture,
short external contacts, or dispose the battery pack in fire or
water. DO NOT attempt to open or service the battery pack.
Dispose of used batteries according to local recycling guidelines
in your area.
A backup battery cell is embedded into your device to prevent data
loss in instances when the removable battery pack is removed or
completely discharged. This backup battery cell will support the
system for a maximum of 60 minutes only.
NOTE: To enable the internal battery cell to provide backup power
supply, charge your device with the main battery pack, for at least 3.5
hours.
(a) Position the battery pack, making sure the battery pack fits the
shape of the battery compartment.
(b) Slide the battery pack into the battery bay until it clicks into place.
2 Charge your device
For initial use, you need to charge your device for about 16 hours. After
that, you can charge it everyday to recharge the battery to full capacity.
You can charge your device using the USB charging cable or the
docking station.
To Next Page
Loading...
