EasyManuals Logo

Unitech PA500 User Guide

Unitech PA500
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
Federal Communication Commission Interference
Statement
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following three conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
(3) This device shall automatically discontinue transmission in
case of either absence of information to transmit or operation
failure.

Table of Contents

Other manuals for Unitech PA500

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Unitech PA500 and is the answer not in the manual?

Unitech PA500 Specifications

System Memory IconSystem Memory
SDRAM64 MB
Flash ROM64 MB
Display IconDisplay
display resolution240x320 QVGA
display typeColor Transflective TFT
touch screenyes
Laser Bar Code Scanner IconLaser Bar Code Scanner
scan rate104 scans/sec ± 12 scans/sec
scan angle default47°±3°
scan angle reduced35°±3°
Power IconPower
main battery voltage3.7 V
main battery capacity2200 mAh
rechargeable time3.5 hours
Operating Environment IconOperating Environment
operating temperature32°F to 122°F (0°C to 50°C)
storage temperature-4°F to 140°F (-20°C to 60°C)
relative humidity5% ~ 95% (non-condensing)
Weight and Dimensions IconWeight and Dimensions
weight with battery and scan engineUnder 213 g
length126 mm
height23 mm

Related product manuals