- 40 -
Read RFID Tags
1. Start Reads : Start/Stop reading
2. Ready : Module status
3. Tag Read Coverage : Antenna power
4. Home : Return to the main page
5. Exit : Exit application
And setup the setting like below
Tag Selection : On EPC
Selection Address : 1
Selection Mask : 12
Select Tags not matching mask : Unchecked.
Then it will only show the tag “1234 0000
0000000000000000”
If Select Tags not matching mask is checked.
It will show the tag “5678 0000 0000 0000
00000000”
7. Save : Save the setting
8. Cancel : Exit this page without saving
9. Restore Defaults : Restore the setting
To Next Page
Loading...
