Unitech PA692

- 9 -
Charging the Battery
Beforeusingtheterminalforthersttime,youneedtochargeitforabout
16 hours. After that, you can charge the terminal for 4 hours to recharge the
battery to full capacity. Charge the terminal using the USB charging cable or
the docking station.
CAUTION: Turn ON the backup battery switch before charging the battery.
Data you entered may not be properly stored until the built-in
backup battery has been adequately charged.
CAUTION!OperatingtheterminalforthersttimewithouttheACadapter,and
without fully charging the backup battery may result in loss of data
stored in RAM memory. When the main battery is removed, the
backup battery retains RAM data in memory for 2 hours. Please
fully charge the backup battery to avoid data loss in RAM memory.
1. Press and hold the release button on both sides of the USB charging
cableandconnectittothePA692(1).
2. Plug the AC adapter cable into the power jack of the USB charging cable
(2).PlugtheACadaptercordintoanelectricaloutlet(3).