Unitronics Vision V130-J Series - Technical Specifications - High Speed and Analog Inputs; High-Speed Input Frequency Ratings; Analog Input Configuration and Performance

Vision™PLC+HMI
Unitronics
17
High Speed Input
Up to 50 meters, shielded, see Frequency table below
High speed inputs
Specifications below apply when wired as HSC/shaft-encoder. See Note 2
Frequency, HSC
Driver type
pnp/npn
Push-pull
Cable length (max.)
10m
95kHz maximum
200kHz maximum
25m
50kHz maximum
200kHz maximum
50m
25kHz maximum
200kHz maximum
Frequency, Shaft-encoder
Driver type
pnp/npn
Push-pull
Cable length (max.)
10m
35kHz maximum
100kHz maximum
25m
18kHz maximum
100kHz maximum
50m
10kHz maximum
100kHz maximum
Duty cycle
40-60%
Resolution
32-bit
Notes:
2. V130/V350/V130J/V350J/V430J-TRA22 models comprise a total of 12 inputs.
All 12 inputs may be used as digital inputs. They may be wired in a group via a single jumper
as either npn or pnp.
In addition, according to jumper settings and appropriate wiring:
- Inputs 5 and 6 can function as either digital or analog inputs.
- Input 0 can function as a high-speed counter, as part of a shaft-encoder,
or as normal digital inputs.
- Input 1 can function as either counter reset, normal digital input, or as part of a shaft-encoder.
- If input 0 is set as a high-speed counter (without reset), input 1 can function
as a normal digital input.
- Inputs 7-8 and 9-10 can function as digital, thermocouple, or PT100 inputs; input 11 can also serve as the
CM signal for PT100.
3. If you configure an input as high-speed, you can use an end-device that comprises push-pull drive type.
In this case, the high-speed input voltage ratings for npn/pnp apply.
Analog Inputs
Number of inputs
2, according to wiring as described above in Note 2
Input type
Multi-range inputs: 0-10V, 0-20mA, 4-20mA
Input range
0-20mA, 4-20mA
0-10VDC
Input impedance
37Ω
12.77kΩ
Maximum input rating
30mA, 1.1V
±15V
Galvanic isolation
None
Conversion method
Voltage to frequency
Normal mode
Resolution, except 4-20mA
14-bit (16384units)
Resolution, at 4-20mA
3277 to 16383 (13107 units)
Conversion time
100ms minimum per channel. See Note 4
Fast mode
Resolution, except 4-20mA
12-bit (4096 units)
Resolution, at 4-20mA
819 to 4095 (3277 units)
Conversion time
30ms minimum per channel. See Note 4
Full-scale error
±0.4%
Linearity error
±0.04%
Status indication
Yes. See Note 5