Unitronics Vision V130-J Series - Technical Specifications - Outputs; Digital Output Specifications

Vision™PLC+HMI
Unitronics
19
Notes:
7. The device can also measure voltage within the range of -5 to 56mV, at a resolution of 0.01mV.
The device can also measure raw value frequency at a resolution of 14-bits (16384). Input ranges are shown
in the following table:
Type
Temp. Range
Type
Temp. Range
mV
-5 to 56mV
N
-200 to 1300˚C (-328 to 2372˚F)
B
200 to 1820˚C (300 to 3276˚F)
R
0 to 1768˚C (32 to 3214˚F)
E
-200 to 750˚C (-328 to 1382˚F)
S
0 to 1768˚C (32 to 3214˚F)
J
-200 to 760˚C (-328 to 1400˚F)
T
-200 to 400˚C (-328 to 752˚F)
K
-200 to 1250˚C (-328 to 2282˚F)
Digital Outputs
Number of outputs
4 relay. See Note 8
Output type
SPST-NO (Form A)
Isolation
By relay
Type of relay
Tyco PCN-124D3MHZ or compatible
Output current
(resistive load)
3A maximum per output
8A maximum total per common
Rated voltage
250VAC / 30VDC
Minimum load
1mA, 5VDC
Life expectancy
100k operations at maximum load
Response time
10ms (typical)
Contact protection
External precautions required (see Increasing Contact Life Span in the
product’s Installation Guide)
Notes:
8. Outputs 4, 5, 6, and 7 share a common signal.
Transistor Outputs
Number of outputs
4 npn (sink). See Note 9
Output type
N-MOSFET, (open drain)
Galvanic Isolation
None
Maximum output current
(resistive load)
100mA per output
Rated voltage
24VDC
Maximum delay OFF to ON
1s
Maximum delay ON to OFF
10s
HSO freq. range with resistive
load
5Hz-200kHz (at maximum load resistance of 1.5kΩ)
Maximum ON voltage drop
1VDC
Short-circuit protection
None
Voltage range
3.5V to 28.8VDC
Notes:
9. Outputs 0, 1, 2 and 3 share a common 0V signal.
The 0V signal of the output must be connected to the controller’s 0V.