EasyManua.ls Logo

Unitronics Vision V280 - Operand Types; Kit Contents; Alert Symbols and General Restrictions; Environmental Considerations

Unitronics Vision V280
15 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
V230/280/290
2
Unitronics
Operand Types
Memory Bits 4096 │Memory Integers, 16-bit, 2048 │Long Integers, 32-bit,
256 │Double Word, 32-bit unsigned, 64 │Memory Floats, 32-bit, 24 │
Timers, 32-bit, 192 │Counters, 16-bit, 24
Additional product documentation is in the Technical Library, located at www.unitronicsplc.com.
Technical support is available at the site, and from support@unitronics.com.
Kit Contents
Vision controller
Grounding hardware
Mounting brackets (x4)
Rubber seal
3 pin power supply connector
Extra set of keyboard slides, according to model
5 pin CANbus connector
CANbus network termination resistor
Alert Symbols and General Restrictions
When any of the following symbols appear, read the associated information carefully.
Symbol
Meaning
Description
Danger
The identified danger causes physical and property damage.
Warning
The identified danger could cause physical and property damage.
Caution
Caution
Use caution.
▪ Before using this product, the user must read and understand this document
▪ All examples and diagrams are intended to aid understanding, and do not guarantee operation
Unitronics accepts no responsibility for actual use of this product based on these examples
▪ Please dispose of this product according to local and national standards and regulations
▪ Only qualified service personnel should open this device or carry out repairs
Failure to comply with appropriate safety guidelines can cause severe injury or property damage
▪ Do not attempt to use this device with parameters that exceed permissible levels
▪ To avoid damaging the system, do not connect/disconnect the device when power is on
Environmental Considerations
▪ Do not install in areas with: excessive or conductive dust, corrosive or flammable gas,
moisture or rain, excessive heat, regular impact shocks or excessive vibration, in
accordance with the standards given in the product’s technical specification sheet
▪ Ventilation: 10mm space required between controller’s top/bottom edges & enclosure walls
▪ Do not place in water or let water leak onto the unit
▪ Do not allow debris to fall inside the unit during installation
▪ Install at maximum distance from high-voltage cables and power equipment