Universal Audio Apollo Twin X User Manual

Apollo Twin X Hardware Manual Quick Start 15
Hardware Setup
Connect to Computer
1. Connect a Thunderbolt 3 cable (not included) to the Thunderbolt 3 port on Apollo
Twin X's rear panel.
2. Connect the other end of the Thunderbolt 3 cable to an available Thunderbolt 3
port* on the computer.
*Note: With Mac computers only, Apollo Twin X can be connected to Thunderbolt
1 and Thunderbolt 2 ports by using the Apple Thunderbolt 3 to Thunderbolt 2
Adapter in conjunction with a Thunderbolt 2 cable. With Windows computers,
connections to Thunderbolt 1 or Thunderbolt 2 ports are not supported.
Connect to Power
Caution: Before powering Apollo Twin X on or off, lower the volume of the monitor
speakers (if connected) and remove headphones from your ears.
1. Connect the included power supply to an AC outlet (Apollo Twin X cannot be bus
powered).
2. Connect the locking power supply barrel to the rear panel of Apollo Twin X. Align
the two tabs on the power cable's connector to the notches on the input, then
rotate the barrel clockwise to prevent accidental disconnection.
Important: After ensuring the locking barrel tabs are aligned with the chassis slots
and the barrel is fully inserted, rotate the barrel to secure the connector.
3. Apply power to Apollo Twin X using the rear panel's power switch. Apollo Twin X is
now ready for Software Setup.
12VDC
1. Align Tabs
2. Rotate to Lock

Universal Audio Apollo Twin X Specifications

General

Type	Audio Interface
Connectivity	Thunderbolt 3
Headphones	1 x 1/4"
AD/DA Conversion	24-bit/192kHz
Simultaneous I/O	10 x 6
Number of Preamps	2
Input Channels	2
Output Channels	4
UAD Plug-in Support	Yes
Monitor Outputs	2
Inputs	2 x XLR/TRS combo, 1 x Hi-Z Instrument
Outputs	2 x Monitor, 2 x Line
Phantom Power	Yes
Weight	2.35 lbs
Digital Inputs	1 x Optical Toslink (ADAT/SPDIF)
UAD Plug-in Processing	Realtime UAD Plug-in Processing
Included Software	Realtime Analog Classics Plus plug-in bundle
Operating System	Mac, Windows
Thunderbolt Connectivity	Yes (Thunderbolt 3)
DSP Processing	UAD-2