(7) Monitor Source Buttons
Important: Output pair OUT 1-2 and/or OUT 3-4 must be selected to hear audio from your
computer.
The Monitor Source buttons select the audio that you’ll hear in the monitor and headphone
outputs. When a monitor source button is lit, that source is routed to the speakers and
headphones.
You can choose to monitor either the mic/line/instrument inputs (direct monitoring), outputs
from the computer, or both.
IN (Direct) – The IN 1-2 and IN 3-4 buttons route Volt’s hardware inputs directly to the monitor
outputs. Direct monitoring allows you to listen to your inputs through the device, without any
software latency.
OUT – The OUT 1-2 and OUT 3-4 buttons route audio from the computer to the monitor
outputs. Enable these buttons to hear sound from the audio software.
Monitor source notes
To Next Page
Loading...
