Universal Robots UR e Series Hardware Manual

Activate the emergency stop push-button to immediately stop all robot motion.
According to IEC 60204-1 and ISO 13850, emergency devices are not safeguards. They
are complimentary protective measures and are not intended to prevent injury.
The risk assessment of the robot application shall conclude if additional emergency stop
buttons are need. Emergency stop push-buttons must comply with IEC 60947-5-5 (see
section4.4.2. Safety I/Oon page34).
Movement Without Drive Power
In the unlikely event of an emergency, you can use forced back-driving where you must
move the robot joint/s, but robot power is either impossible or unwanted.
To perform forced back-driving you must push, or pull, the robot arm hard to move the
joint. Each joint brake has a friction clutch that enables movement during the high forced
torque.
Forced back-driving is only intended for emergency purposes.
Hardware Manual 13 UR5e
1.Safety
Copyright © 2009–2022 by UniversalRobotsA/S. All rights reserved.

Universal Robots UR e Series Specifications

General

Brand	Universal Robots
Model	UR e Series
Category	Robotics
Language	English