Why is my Universal Robots Controller turning on then shutting down?
If the Universal Robots Controller turns on for a few seconds and then shuts down, it may be because the Power ON button was pressed for too long. Press the button for only 1-2 seconds; pressing it for more than 5 seconds will cause the controller to shut down.
What to do if my Universal Robots Controller does not turn on?
If the Universal Robots Controller does not turn on, ensure that the power source is wired correctly. Also, for DC power, verify that the DC source connection polarity is correct, as reverse polarity can cause permanent damage.
Why is my Universal Robots controller robot performance unstable?
If the robot performance is unstable, check that the input voltage is within the specified range. Also, check the grounding to avoid ground loops or loose screws.
What to do if Universal Robots Controller does not turn on or robot performance is unstable?
If the Universal Robots Controller does not turn on or the robot performance is unstable, verify that the DC input is within the specifications. Also, ensure that the DC supply has enough charge to supply the initial current to the system.
What to do if Universal Robots Robotics fails during power-up?
If your Universal Robots Robotics system fails during power-up, there are several potential causes: * The Teach Pendant may be incorrectly connected, so check its connection. * The 48V power supply (including its control wires) may be incorrectly connected; verify these connections. * There might be a reverse polarity in the 48V voltage supply; correct the polarity.
What to do if Universal Robots Robotics fails during operation?
If your Universal Robots Robotics system fails during operation, it could be due to: * The input voltage for the 48V supply dropping below 19V. Ensure the input voltage is above 19V. * The configuration file being modified incorrectly. Review and correct the configuration file.
Why does my Universal Robots Robotics system seem unstable?
An unstable Universal Robots Robotics system can stem from several issues: * An unstable 48V power supply. Stabilize the 48V power supply. * Voltage supply not within +/- 1% tolerance. Ensure the voltage supply is within the specified tolerance. * Incorrect grounding, potentially from ground-loops or loose screws. Check and correct any grounding issues.
General| Payload | 3 kg, 5 kg, 10 kg, 16 kg |
|---|---|
| Power Supply | 100-240 VAC, 50-60 Hz |
| IP Rating | IP54 |
| Number of Axes | 6 |
| Tool TCP Speed | 1 m/s |
| Degrees of Freedom | 6 |
| Protection Rating | IP54 |
| Model | UR3e, UR5e, UR10e, UR16e |
| Reach | 500 mm, 850 mm, 1300 mm |
| Weight | 11.2 kg, 20.6 kg |
| Repeatability | ± 0.03 mm |
| Operating Temperature | 0 to 50 °C |
| Programming Method | Teach pendant (PolyScope), script, URCap |
| Communication Interfaces | Ethernet, Digital I/O |
| Safety Standards | EN ISO 10218-1, ISO/TS 15066 |
To Next Page
