MSC-400 Reference Manual
Rev 4
67
Convert RS232 Commands to Smart Macro Group
2. In the pop-up, highlight TOOLS and then click CONVERT TO SMART MACRO GROUP. The new
SMART MACRO GROUP will appear at the BOTTOM of TREE VIEW.
3. To review the group, click the ‘+’ next to the GROUP NAME to expand the list.
4. These commands are now ready to be used either as individual commands or in Macros, except for
commands that require press and hold functions such as Volume UP/DOWN.
IMPORTANT NOTE - RS232 Volume Commands MUST be cond for: Repeat, Ramp Start and
most important Ramp Speed. If these settings are not properly cond, either the volume will not
ramp at all or the volume will ramp from ‘0 to deafening’ in less than a second. See Section:
RS232 REPEAT, RAMP START AND RAMP SPEED for additional Information.
TIP - When working with RS232 Commands, there may be functions that should be added to
the remote Soft Keys, using the LCD Button Editor. By minimizing both the MSC and MX/TX
Editors to fit on screen, the RS232 Smart Macro Group can be reviewed in MSC-Editor and
desired functions can be added to the remote in MX/TX Editor. MSC400 and MX/TX Editor
Split Screen
1
2
To Next Page
Loading...