UP Plus 2 3D Printer User Manual v 2013.10.24
If you find you cannot get the platform any higher, then:
copy the value from “Max: xx” into the “To:” box as per
diagram and click “To:”.
Now to increase the Max height, click “Set Nozzle Height”
and click “Yes” to save it.
You will notice that the Max value has increased by 1mm.
Repeat the above “Note 1” until the platform is 0.2mm
away from the nozzle.
TIP a: Once you have setup the nozzle height once, you should do not need to do it again as it is
now saved in the printer.
TIP b: You may need to regularly recalibrate nozzle height after moving the printer, or if you find
the models are not adhering to the platform properly, or are warping.
TIP c: If you happen to crash the platform into the nozzle while setting the height adjustment,
always re-initialise the printer before undertaking any further operations and start again. You do
not need to initialise the printer after every print. Only when switching on the printer or cancelling
a print.
To Next Page
Loading...
Need help?
General
