UP Plus 2 User Manual

UP Plus 2 3D Printer User Manual v 2013.10.24
Example of a good extrusion after doing an extrude.
8.1 Withdrawing filament from the Extruder
Click on the menu “3DPrint” -> “Maintenance” -> “Withdraw”. The printer extruder will now
start to heat. (Takes approximately 10mins)
After the printer nozzle has warmed up to 260°C, the printer will beep. Gently pull out the fila-
ment from the top of the extruder head. After the printer beeps a second time (meaning the extru-
sion process is complete), pull away the piece of filament. Cut the end of the filament flat.

UP Plus 2 Specifications

General

Nozzle Diameter	0.4 mm
Filament Diameter	1.75 mm
Print Material	ABS, PLA
Connectivity	USB
Print Technology	Fused Filament Fabrication (FFF)
Supported OS	Windows, Mac OS X
Print Speed	10-100 mm/s
Power Requirements	110-240V, 50-60Hz
Weight	5 kg
Build Volume	140 x 140 x 135 mm