UP Plus 2 3D Printer User Manual v 2013.10.24
to 105°C before beginning to print.
Click menu “3D Print->Print”, and the print dialog box pops up. Choose “Preferences” to set the
printing parameters. Click “OK” to begin to print.
(Windows version) (Mac version)
10.3 Options During Printing:
• Stop All: By pressing “Stop All” or the “Stop Print” icon will terminate the current print.
You can reprint the last job by clicking “Tools” and “Print Again”. By stopping the print,
the software looses track of material used.
• Pause Print: Clicking “Pause Print” will pause the print job, and bring the platform down.
This is a handy feature to change colours of filament, insert objects into your print.
When paused you can “Withdraw” and “Extrude” filament. Warning: By pausing keeps
the extruder and platform heater working, it is not suggested to pause for long periods of
time.
• Status bar: The bottom status bar shows the current layer that is currently being printed
and the remaining time to complete the job.
• Initialise Switch: By holding down the front switch on the printer, will abort the current
print job, bring the platform down and then put the printer into sleep mode.
To Next Page
Loading...
Need help?
General
