3
Power Pack (Battery Power or Mains Power).
Fully integrated power pack consisting of Motor, Pump, Relief valve, non return Check,
Return filter with dip stick for checking oil level. Pump is fitted with internal suction
strainer. Return filter is fitted with a breather and is used for topping up if oil is required.
The tank is fitted with a drain plug on the bottom face. A quick release coupling for
checking oil pressure is fitted on top of the pressure port.
Power Pack (I.C. Engine).
Engine is fitted with a separate pump. Oil is fed from a separate tank which is fitted with a
return filter and dip stick. Return filter is fitted with a breather and is used for topping up if
oil is required. The tank is fitted with a drain plug on the bottom face. The relief valve is
mounted independently in close proximity to the pump together with a quick release
coupling for checking hydraulic pressure
The engine is fitted with electric start with its own independent start battery. The engine
can be started from the engine’s start / stop key switch and from the remote start / stop
push button fitted in the cage.
Safety Systems.
Full fail-safe hydraulic and electrics as required by EN280 and the Machinery Directive.
Outriggers are pressure sensitive to prevent operating the booms until the outriggers are
in full contact with the ground. Outrigger condition is monitored constantly and full visual
indication is given by 4 independent LED’s mounted on the Ground control panel.
It is not possible to raise the outriggers when the booms are extended. In case of power
failure all booms can be lowered and the slew operated using a manual hand pump fitted
in the cage. From the ground the top and bottom booms can be lowered manually by
actuating the manual override valves fitted to the Bottom and Top cylinders. The slew can
be operated by manually turning the slew motor shaft.
TECHNICAL CHARACTERISTICS
To Next Page
Loading...
