Upright X33RT - RCD;ELCB AC Outlet (option); Flashing Light (option); Lanyard Anchor Points (option); Non-Slip Tread Grip

ta detac ol si )eciv eD tner ruC lau dis eR( DCR ehT
ot stiuc ric trohs tsniaga tcet orp lliw dna dnuorg eht
lliw DCR eht tiuc ric trohs a si ereht nehW .htrae
tuo mrof talp eht ot rewop CA v032 eht nwod tuhs -
loot rewop eht tcen noc sid tel tuo eht tes er oT .tel
eht ta DCR eht tes er dna xob mrof talp eht morf dael
res deniart a llac stsis rep mel borp eht fI .dnuorg -
vice technician.
■
Flashing Light (option)
The flash ing light alerts peo ple that the RT is pres -
ta sehsalf thgil ehT .gni vom si RS eht taht dna tne
enig ne RS eht emit yna dno ces rep hsalf eno tuoba
is run ning. There is no ON/OFF switch for the flash -
ing light, it can not be turned off while the RT is run -
ning.
■
Lanyard Anchor Points (option)
,mrof talp eht fo roolf eht no srohc na ruof era erehT
one at the front of the roll-out deck, one at the back
talp eht fo edis hcae no eno dna ,mrof talp eht fo -
form.
NOTE
These anchors are not for lifting or tying down
the machine.
na eht ot noit cet orp llaf ruoy hcat ta dluohs uoY -
.ti eriuq er selur krow fi srohc
page 2 - 4 Rev A SR3370 & SR2770 – 13184A
2. Safety Devices
The RT must be on a firm surface capable of
w ithstanding all load forces imposed by the aerial
platform in all operation conditions before the
stabilisers are used.
■
RCD/ELCB AC Outlet (option)
Figure 2.11 - RCD/ELCB AC Outlet
RCD
Power Input
Connector
Power Outlet
At Platform
NOTE