10. Stowing and Transporting
■
Stowing
At the end of each work day (or in prep a ra tion for
trans port ing, push ing, lift ing, or stor age) a qual i fied
op er a tor should put the RT into its stowed po si tion
then lock it.
The cor rect stowed po si tion is shown here.
Figure 10.1 - Correct Stowed Position
To bring the RT into the Stowed Po si tion use the
con trols on ei ther the ground con trol box or the
plat form con trol box to:
1. Fully lower the platform.
2. Use the stabiliser controls to completely
raise all four of the stabilisers.
3. Close the platform entry gate and close all
the doors on the machine.
To lock an RT:
Figure 10.2
1.
Push the Emergency Stop switch down
(OFF) and set the Main Power switch to
OFF then remove the key (see Figure
10.2).
Figure 10.3
2.
Turn the Battery switch ~ OFF and
padlock it (see Figure 10.3).
Figure 10.4
SR3370 & SR2770 – 13184A Rev A page 10 - 1
To Next Page
Loading...
