■
Lanyard Anchor Points
There are four an chors on the floor of the plat form,
one at the front of the roll-out deck, one at the back
of the plat form, and one on each side of the plat -
form.
NOTE
These anchors are not for lifting or tying down
the machine.
NOTE
You should attach your fall protection to the
anchors if work rules require it.
■
Electrical Outlet
Figure 11.12 - Electrical Outlet
The elec tri cal out let on the plat form, and its power
ca ble, are de signed to sup ply 2 kW of con tin u ous
duty power to run power tools of var i ous sorts. The
power can come from ei ther the op tional ac gen er -
a tor, dis cussed else where in this chap ter, or from
an elec tri cal source out side the RT. If you use an
elec tri cal source out side the RT be sure you dis -
con nect it be fore you drive the RT away.
■
Non-Marking Tyres
These are tyres suited for us ing the RT in in door
sit u a tions.
■
Alternative Power Options
There are a num ber of al ter na tive power op tions to
the stan dard die sel en gine.
❍
Gasoline powered engine
❍
LPG powered engine
❍
Combination LPG/Gasoline powered
engine
■
Stabilisers
Sta bi lis ers / No Stabilisers
page 11 - 4 Rev A SR3370 & SR2770 – 13184A
11. Options
To Next Page
Loading...
