PROGRAMMING MODE
http://www.miwiurmet.com.pl e-mail:miwi@miwiurmet.com.pl
16
4.02 INDIVIDUAL OPENING CODES RESTORE
P
4
0
2
To activate this function please press
#
button. During this process
on LED display will be shown this communication:
-
-
-
-
4.03 GENERAL OPENING CODES RESTORE
P
4
0
3
To activate this function please press
#
button. During this process
on LED display will be shown this communication:
-
-
-
-
4.04 ALL DATA RESTORE
P
4
0
4
This function restore:
• individual opening codes
• general opening codes,
• logical user codes,
To activate this function please press
#
button. During this process
on LED display will be shown this communication:
-
-
-
-
4.08 EEPROM MEMORY DELETING AND RESET
P
4
0
8
This function restores default settings of all programming steps and
logical user code (logical user code re-mapping will be lost).
To activate this function please press
#
button. During this process
on LED display will be shown this communication:
-
-
-
-
In the end of this process power supplier will RESET.
4.09 DEFAULT SETTINGS P1 P2 AND P7 RESTORE
P
4
0
9
This feature applies to restore:
• Restore main setup,
• Restore times,
• Advanced functions.
To activate this function please press
#
button. During this process
on LED display will be shown this communication:
-
-
-
-
5. LOGICAL USER AND OPENING CODES
5.01 LOGICAL USER CODES PROGRAMMING
P
5
0
1
After pressing the
#
button on the LED display will be shown this
communication:
C
F
F
F
C riser number (1 or 2)
FFF physical code (address set by jumpers in the
house phone in the range 1-255
Logic user code can be associated to every physical user code.
To do it:
• Enter the number of riser to which house phone is connected,
• Enter physical code of the house phone,
• Confirm by pressing
#
button
If the physical code was not associated with any logical user code
on the LED display will be shown this communication:
L
L
L
L
If physical code has been already associated, than on the LED
display will be shown programmed code.
Than we are able to:
•
Keep previous code or enter new one in range from 1-9999,
than confirm,
•
Confirm entered code by pressing and hold for a while the
#
button. If we just press the
#
button than the system will
propose first free logical user code, we can confirm by pressing
and holding
#
button, or just press the
#
button to continue
searching.
Searching process of first free logic code will be shown on LED
display with this kind of communication:
-
-
-
-
To Next Page
Loading...
Need help?
General
