6. In the configuration utility for your WPS wireless adapter, enter the PIN from the
router's start page. For instructions on installing your wireless adapter, see your
wireless adapter’s documentation.
7. The wireless adapter detects the WPS settings of the access point and negotiates a
secure (WPA2) wireless connection to the network.
8. If the WPS connection does not complete, unplug the disconnec and then
reconnecting the access point's power supply, then repeat the installation
procedure using the new PIN code on the access point's start page.?.
If you use an external registrar to configure the access point using WPS, all devices
connecting to the access point must do so via the external registrar.
You have successfully completed the installation procedure. Please register the access
point at
www.usr.com/productreg/.
© 2007 U.S. Robotics Corporation
file:///G|/CSO/T-Writer%20Repository/Networking/5455...MAXg%20CR%20AP/Regulatory%20Preview/install_wps.html (2 of 2)4/24/2007 5:15:44 PM
To Next Page
Loading...
