Wireless MAXg Access Point:
User Guide
Wi-Fi Protected Setup™ Configuration
The Wireless MAXg Access Point supports Wi-Fi Protected Setup™ (WPS). You can use
WPS to configure your wireless network using a push button or PIN code.
Only certain wireless adapters in Windows Vista and Windows XP, Service Pack 2, can use
Wi-Fi Protected Setup. See the documentation for your wireless adapter to determine
whether your wireless client can configure the Wireless MAXg Access Point using Wi-Fi
Protected Setup.
To configure the access point for WPS, follow these steps:
Note to reviewers: This draft requires two perspectives for WPS: using an
external registrar and using an internal registrar. Please ignore the following
set of steps.
1. Be ready to start WPS on your wireless adapter.
Once you reboot the access point during this procedure, you have 2 minutes to
start the WPS setup on your wireless adapter.
2. Reboot the access point by disconnecting and then reconnecting its power supply.
3. Start a web browser.
4.
Log in to configuration pages for the access point.
5. In the lower right corner of the page is an eight-digit WPS PIN. Note the PIN
because you need it in oder to configure the router using WPS.
file:///G|/CSO/T-Writer%20Repository/Networking/5455...MAXg%20CR%20AP/Regulatory%20Preview/install_wps.html (1 of 2)4/24/2007 5:15:44 PM
To Next Page
Loading...
