Wireless MAXg Access Point:
User Guide
Log
This page lets capture system events in a log and send it to your syslog server.
To set up the log:
1. Select System log.
The access point prompts you for a LAN IP address.
2. Enter a LAN IP address.
The LAN IP address must identify a computer that is running a syslog daemon.
Your syslog server (sometimes referred to as daemon) must be configured to run
on port 514 using UDP protocol.
3. Click Save.
© 2007 U.S. Robotics Corporation
file:///G|/CSO/T-Writer%20Repository/Networking/5455%20MAXg%20CR%20AP/Regulatory%20Preview/log.html4/24/2007 5:15:45 PM
To Next Page
Loading...
