Sending Functions
OPERATION GUIDE 5-13
5
Adjusting Density
Use the procedure below to adjust the density when scanning the originals.
The table below shows the available settings.
The procedure for adjusting the density is explained below.
1 Press the Send key.
2 Place the originals on the platen.
3 Press the Function Menu key. Function Menu
appears.
4 Press the U or V key to select [Density].
5 Press the OK key. Density appears.
6 Press the U or V key to select [Auto] or [Manual].
If you select [Manual], press the OK key, and then
select the density on the next screen.
7 Press the OK key.
Completed. is displayed and the screen returns to
the basic screen for sending.
8 Specify the destination, and press the Start key to
start sending.
Item Detail
Manual Adjust density using 7 levels.
Auto Optimum density is selected according to the
density of the original.
Function Menu:
a
b
*********************
2
Original Size
T
3
Original Image
T
[ Exit ]
Density:
a
b
*********************
2
Manual
To Next Page
Loading...
Need help?
General
