Why are my Utax All in One Printer printouts wrinkled?
If your Utax All in One Printer's printouts are wrinkled, it could be due to damp paper. Replace the paper with new paper. Also, ensure the paper is set in a proper orientation, and change the orientation if needed.
Why my Utax CD 1028 Fax Machine cannot send documents?
If your Utax Fax Machine cannot send documents, it could be due to several reasons: * Check if the modular cord is connected correctly and connect it properly if it isn't. * If a 'Communication error' is displayed, identify and fix the cause of the error, then try sending the document again. * Verify whether TX (transmission) restriction is activated. If it is, cancel the TX restriction to enable sending.
What to do if Utax CD 1028 Fax Machine shows 'Sub address/Polling limit exceeded'?
If your Utax Fax Machine displays 'Sub address/Polling limit exceeded', it means the sub address box or polling box capacity is full. To resolve this: 1. Press the OK key to cancel the current job. 2. Print or delete the data in the sub address box to free up space. 3. Try performing the job again.
How to fix 'Add paper in cassette' error on Utax CD 1028?
If your Utax Fax Machine displays 'Add paper in cassette 1 (~3). or Add paper in MP tray.' message, follow these steps: * Ensure that the indicated cassette or MP tray is not out of paper. Add paper of the same size as indicated. When the type of printing paper is specified, the necessary paper types are also displayed. * To use another paper source, select the paper source and press the OK key. Alternatively, press [Paper] (the Right Select key), select the desired paper source, and then press the OK key. * If the type of printing paper is specified, and the cassette for the specified paper type is not available, press [Paper] (the Right Select key), select another paper source, and then press the OK key. * Also, make sure that the cassette is securely loaded. Remove the cassette...
How to clean Utax All in One Printer dirty printouts?
If your Utax All in One Printer produces dirty printouts, check if the platen or the document processor is dirty and clean it. Also, check if the charger wire is dirty and clean it as well.
What to do if Utax All in One Printer says insufficient memory?
Further scanning cannot be performed due to insufficient memory. Press the OK key to print the scanned pages. Press the Cancel key to cancel the printing job.
Why Utax CD 1028 cannot use the remote switching function?
If your Utax Fax Machine cannot use the remote switching function, it could be due to the following reasons: * If a pulse line is used, some phones may transmit tone signals using buttons. Refer to the operation manual of your phone set for guidance. * Check the registration to ensure the remote switching number is correct. The default number is 55.
Why Utax CD 1028 cannot use sub address relay broadcast communication?
If your Utax Fax Machine cannot use sub address relay broadcast communication, free up some space in memory and then send, or simply make some free space in memory.
What to do if Utax All in One Printer says the phone receiver is off the hook?
Put down the receiver.
Why Utax CD 1028 cannot perform sub address transmission?
If you cannot perform sub address transmission on your Utax Fax Machine, it could be due to the following reasons: * Ensure that the recipient fax machine is equipped with a sub address transmission feature, as it is required for this function to work. * Verify that the entered sub address or sub address password is identical to the sub address or sub address password registered in the recipient fax machine. If your entry is correct, check with the recipient. Note: This machine does not use a sub address password for reception. * Check with the recipient to ensure there is free space available in the memory of their fax machine.
General| Brand | Utax |
|---|---|
| Model | CD 1028 |
| Category | Fax Machine |
| Language | English |
To Next Page
