Why does my Utax All in One Printer paper often jam?
Paper jams can occur for several reasons. Ensure the paper is loaded correctly. If the paper is of a supported type and in good condition, try removing it, turning it over, and reloading it. Replace curled, folded, or wrinkled paper with new paper. Also, check for and remove any loose scraps or jammed paper inside the Utax All in One Printer.
Why Utax CD 1028 cannot use sub address bulletin board communication?
If your Utax Fax Machine cannot use sub address bulletin board communication, it could be due to the following reasons: * If the other party’s fax machine does not have the same sort of sub address bulletin board communication function, it cannot receive faxes via a sub address bulletin board. Check with the recipient. * Verify that the entered sub address or sub address password is correct. If your entry is correct, check with the recipient.
Why Utax CD 1028 cannot use sub address relay broadcast communication?
If your Utax Fax Machine cannot use sub address relay broadcast communication, free up some space in memory and then send, or simply make some free space in memory.
Why Utax CD 1028 cannot use the remote switching function?
If your Utax Fax Machine cannot use the remote switching function, it could be due to the following reasons: * If a pulse line is used, some phones may transmit tone signals using buttons. Refer to the operation manual of your phone set for guidance. * Check the registration to ensure the remote switching number is correct. The default number is 55.
What to do if Utax CD 1028 Fax Machine says 'The phone receiver is off the hook'?
If your Utax Fax Machine displays 'The phone receiver is off the hook', and you have a commercially available phone connected to the machine, ensure that the handset is hung up.
What to do if my Utax CD 1028 shows 'Machine failure. Call service'?
If your Utax Fax Machine displays 'Machine failure. Call service', try these steps: 1. Turn the main power switch off and then on again. 2. If that doesn't work, unplug the power cord from the outlet, wait a few seconds, and then plug it back in. If the error message persists after these steps, make sure to note the error code, turn off the main power switch, unplug the power cord, and then contact your service representative for further assistance.
Why Utax CD 1028 cannot output from a Sub Address Box?
If your Utax Fax Machine cannot output from a Sub Address Box, ensure that you enter the correct box password.
Why Utax CD 1028 Fax Machine cannot perform encrypted communication?
If your Utax Fax Machine cannot perform encrypted communication, double-check the registrations both at the sender and recipient to ensure they are correct.
Why Utax Fax Machine cannot store memory forwarding data in a Sub Address Box?
If your Utax Fax Machine cannot store memory forwarding data in a Sub Address Box, it could be due to the following reasons: * Ensure that the Sub Address Box is specified correctly. Check the memory forwarding setting. * Ensure that there is free space available in the memory. Receive after the memory has free space, or create free space in the memory.
Why Utax Fax Machine cannot perform memory forwarding using a sub address?
If your Utax Fax Machine cannot perform memory forwarding using a sub address, it could be due to the following reasons: * Ensure that the recipient fax machine is equipped with a sub address transmission feature, as it is required for this function to work. * Verify that the entered sub address is identical to the sub address registered in the recipient fax machine. If your entry is correct, check with the recipient. Note: This machine does not use a sub address password for reception.
General| Brand | Utax |
|---|---|
| Model | CD 1028 |
| Category | Fax Machine |
| Language | English |
To Next Page
