Management
OPERATION GUIDE 11-9
11
17
Press the Z key to select [Account Name:], press
[Change] (the Right Select key), select the
account, and then press the OK key.
NOTE: If the user list is for device administrator and
the device administrator does not log in, [Change] is
not displayed.
18
After entering the user information, press the OK
key again.
Registered. is displayed and the screen returns to
Local User List.
Changing User Properties
User information can be changed. It can be changed only by a user with administrator privileges.
Use the procedure below to change the user properties.
NOTE: Refer to Character Entry Method on Appendix-5 for details on entering characters.
1 Press the System Menu/Counter key on the main
unit operation panel.
2 In the Sys. Menu/Count. menu, press the U or V
key to select [User/Job Account], and then press
the OK key.
3 If user login administration is disabled, the user
authentication screen appears. Enter your login
user name and password and then press [Login].
For this, you need to log in with administrator
privileges. Refer to Adding a User on page 11-6 for
the default login user name and password.
NOTE: If [Netwk Authentic.] is selected as the user
authentication method, press [Menu] (the Left Select
key) to select the authentication destination.
Detail:
C
b
Account Name: 6/6
k
Osaka
[ Change ]
Sys. Menu/Count.:
a
b
*********************
5
User Property
6
Common Settings
[ Exit ]
Login User Name
L
b
*******************
Login Password:
[ Menu ] [ Login ]
To Next Page
Loading...
Need help?
General
