Preparation before Use
OPERATION GUIDE 2-9
2
Setting Date and Time
Follow the steps below to set the local date and time at the place of installation.
When you send an E-mail using the transmission function, the date and time as set here will be printed in the
header of the E-mail message. Set the date, time and time difference from GMT of the region where the machine
is used.
NOTE: Be sure to set the time difference before setting the date and time.
1 Turn on the main power switch.
2 Press the System Menu/Counter key on the main
unit operation panel.
When you are performing user management and
have not logged in, a login screen will appear.
Then, enter the user ID and password to log in.
NOTE: If [Netwk Authentic.] is selected as the user
authentication method, press [Menu] (the Left Select
key) to select the authentication destination.
3 In the Sys. Menu/Count. menu, press the U or V
key to select [Common Settings].
4 Press the OK key. The Common Settings menu
appears.
Login User Name:
L
b
********************
Login Password:
[ Menu ] [ Login ]
Sys. Menu/Count.:
a
b
5
User Property
*********************
7
Copy
[ Exit ]
Common Settings:
a
b
*********************
2
Default Screen
3
Sound
[ Exit ]
To Next Page
Loading...
Need help?
General
