Management
OPERATION GUIDE 11-5
11
Login/Logout
Once you enable user login administration, a login user name and password entry screen appears each time
you use this machine.
Login
Log in using the procedure below.
NOTE: Refer to Character Entry Method on Appendix-5 for details on entering characters.
1 If the screen below appears during the operations,
perform the following login operations.
2 Press the OK key, enter the login user name, and
then press the OK key.
3 Press the V key to select [Login Password], press
the OK key, enter the login password, and then
press the OK key.
4 Check the login user name and password are
correct, and press [Login] (the Right Select key).
NOTE: If [Netwk Authentic.] is selected as the user
authentication method, press [Menu] (the Left Select
key) to select the authentication destination.
Logout
To log out the machine, press the Logout key to return
to the login user name/login password entry screen.
Auto Logout
Logout is automatically executed in the following cases:
• When the Power key is pressed to enter the sleep
mode
• When auto sleep is activated
• When auto panel reset is activated
• When auto low power mode is activated
Login User Name
L
b
*******************
Login Password:
[ Menu ] [ Login ]
To Next Page
Loading...
Need help?
General
