Utax P-3020 MFP - Network Setup (LAN Cable Connection)

8-136
Default Setting (System Menu)
Network Setup
The following network settings are available.
• LAN Interface Setup …8-136
• TCP/IP (IPv4) Setup …8-137
• TCP/IP (IPv6) Setup …8-146
• Protocol Detail …8-151
LAN Interface Setup
Specify the settings for the LAN interface to be used. The default setting is Auto.
Use the procedure below to select the interface.
1 In the Sys. Menu/Count. menu, press the  or  key to
select [System/Network], and press the OK key.
A login screen will appear. Then, enter the user ID and
password with administrator privileges to log in, and
press [Login] (the Right Select key).
2 The System/Network menu appears.
3 Press the  or  key to select [Network Setting].
4 Press the OK key. The Network Setting menu appears.
5 Press the  or  key to select [LAN Interface].
Sys. Menu/Count.: a b
1 Report
2 Counter
*********************
[ Exit ]
3 System/Network
Login User Name: L b
*******************
Login Password:
[ Login ]
System/Network: a b
*********************
2 I/F Block Set.
3 Security Level
[ Exit ]
1 Network Setting
Network Setting: a b
*********************
2 WSD-SCAN
3 WSD-PRINT
1 TCP/IP Setting