Utax P-3020 MFP User Manual

8-142
Default Setting (System Menu)
DHCP Settings
Select whether or not to use the DHCP server. The default setting is On.
Use the procedure below to specify the DHCP setting.
1 In the Sys. Menu/Count. menu, press the  or  key to
select [System/Network], and press the OK key.
A login screen will appear. Then, enter the user ID and
password with administrator privileges to log in, and
press [Login] (the Right Select key).
2 The System/Network menu appears.
3 Press the  or  key to select [Network Setting].
4 Press the OK key. The Network Setting menu appears.
5 Press the  or  key to select [TCP/IP Settings].
6 Press the OK key. The TCP/IP Settings menu appears.
7 Press the  or  key to select [TCP/IP].
Sys. Menu/Count.: a b
1 Report
2 Counter
*********************
[ Exit ]
3 System/Network
Login User Name: L b
*******************
Login Password:
[ Login ]
System/Network: a b
*********************
2 I/F Block Set.
3 Security Level
[ Exit ]
1 Network Setting
Network Setting: a b
*********************
2 WSD-SCAN
3 WSD-PRINT
1 TCP/IP Setting
TCP/IP Settings: a b
*********************
2 IPv4 Setting
3 IPv6 Setting
[ Exit ]
1 TCP/IP

Utax P-3020 MFP Specifications

General

Brand	Utax
Model	P-3020 MFP
Category	All in One Printer
Language	English