Utax P-3020 MFP User Manual

8
8-159
Default Setting (System Menu)
LDAP Security
Select the communication protocol according to the type of security employed by the LDAP server. The default setting
is Off.
NOTE: LDAP must be set to On in Protocol Detail on page 8-151.
The table below shows the available settings.
* You can change the port number using Embedded Web Server RX.
Use the procedure below to make the setting.
1 In the Sys. Menu/Count. menu, press the  or  key to
select [System/Network], and press the OK key.
A login screen will appear. Then, enter the user ID and
password with administrator privileges to log in, and
press [Login] (the Right Select key).
2 The System/Network menu appears.
3 Press the  or  key to select [Network Setting].
4 Press the OK key. The Network Setting menu appears.
Item Description
Off Do not use security employed by the LDAP server.
SSL/TLS Encryption is applied any data communication. To enable LDAP security, the
LDAP port may have to be changed according to the server settings.
Typically, 636* for SSL/TLS is well-known LDAP port.
STARTTLS Encryption is applied any data communication. Typically, 389* for
STARTTLS is well-known LDAP port.
Sys. Menu/Count.: a b
1 Report
2 Counter
*********************
[ Exit ]
3 System/Network
Login User Name: L b
*******************
Login Password:
[ Login ]
System/Network: a b
*********************
2 I/F Block Set.
3 Security Level
[ Exit ]
1 Network Setting
Network Setting: a b
*********************
6 Host Name
7 LAN Interface
[ Exit ]
5 Secure Protocol

Utax P-3020 MFP Specifications

General

Brand	Utax
Model	P-3020 MFP
Category	All in One Printer
Language	English