Troubleshooting
8-6
Error Messages
The following table lists errors and maintenance messages that you can be dealt with by yourself. If
Machine failure.
Call service.
appears, turn off the printer, disconnect the power cord, and contact your service technician.
If
Machine failure. Call service.
or Error occurred. Turn the power switch off and on. is displayed,
turn off the printer then turn it back on to see if the printer has recovered. If the printer has not recovered, turn off the printer,
disconnect the power cord, and contact your service representative or authorized service center.
Some errors cause the alarm to sound. To stop the alarm, press [Cancel].
Message Corrective Action
You can only change the settings selected when logged in as a user with
machine administrator privileges.
The Log in operation failed for the specified number of times so it is no longer
possible to attempt to log in. Contact a system administrator.
It was not possible to connect to the network with the optional wireless network
interface kit.
Check if the access point has been set correctly.
For details, refer to Wireless Network (Wireless network settings) on page 4-83.
This message is displayed when the Job Accounting function is enabled and an
attempt to specify job accounting settings or to register or delete an account
fails. To return the printer to the print-ready status, press [OK].
A machine
administrator right
is required.
Access denied.
You cannot login.
Access point was not
detected.
Account error.
Press [OK].
To Next Page
Loading...
Need help?
General
