EasyManuals Logo

UTC Fire and Security Edwards BPS10A/230 User Manual

UTC Fire and Security Edwards BPS10A/230
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
Remote Booster Power Supply Technical Reference Manual 21
Wire routing
Separate power-limited from nonpower-limited wiring. Wiring within the enclosure
should be routed around the perimeter of the enclosure, not across the circuit
board.
Figure 10: Wire routing
(4)
(4)
(3)
(2)
(1)
Legend
(1) Power-limited wiring area
(2) Route AC supply through knockouts in nonpower-limited area
(3) Battery wiring
(4) Battery
Notes
Maintain 0.25 in. (6 mm) spacing between power-limited and nonpower-limited wiring.
NAC circuits are power-limited and supervised for opens, shorts, and overcurrents. When
configured as auxiliary power circuits, they are power-limited and supervised for shorts and
overcurrents.
Source must be power-limited. Source determines supervision.
Position the battery terminals towards the door.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the UTC Fire and Security Edwards BPS10A/230 and is the answer not in the manual?

UTC Fire and Security Edwards BPS10A/230 Specifications

General IconGeneral
BrandUTC Fire and Security
ModelEdwards BPS10A/230
CategoryPower Supply
LanguageEnglish

Related product manuals