6
4. Test the operation of the pump by pouring water
into the sump basin.
4
CARE AND MAINTENANCE
WARNING: Always disconnect pump from power
source before handling.
At least every three months:
Remove any debris that may build up in the
sump basin to prevent it from interfering with the
operation of the float switch.
Test system for operation.
Remove
debris
1
5. If the lower rod stop is positioned 8 in. from
the top of the rod, the pump will turn on
at approximately 10 in. to 12 in. and o at
approximately 2-1/2 in. To cycle the pump on
and o faster, move the lower oat stop closer
to the oat rod guide.
Float Rod Guide
Lower Float Rod Stop
5
To Next Page
Loading...
Need help?
General
