NOTE: Under the Power Saving Mode, backlight
will be automatically turned off after weight
displayed is unchanged for about 20 seconds.
Backlight will be turned on again by pressing
any key or when a new weight is detected.
4.3.1.2 Turn backlight on: - Without Power
Saving Mode
a. Turn scale on.
b. Press 2 then press ZERO
c. Backlight is tuned on.
NOTE: Backlight under this mode will remain
lit on until manually turned off.
4.3.1.3 Turn backlight off
a. Turn scale on.
b. Press 0 then press ZERO
c. Backlight is turned off.
4.3.2 (OVC) Set Standby Status
4.3.2.1 Employ standby function: - Power Saving
Mode
d. Turn scale on.
e. Press 1 then press ZERO.
f. Power Saving Mode is now employed.
NOTE: Under the Power Saving Mode, the unit
will automatically enter standby mode after
weight displayed is unchanged for about 20
seconds. When the unit is under standby
status, the LO-BAT INDICATOR will light on.
The unit will return to normal operating
mode by pressing any key or when a new weight
(¡ ¡8 divisions) is detected.
4.3.2.2 disable standby function
a. Turn scale on.
b. Press 2 then press ZERO
c. Power Saving Mode is now disabled
4.3.3 Set AUTO POWER OFF Status
This unit is equipped with AUTO POWER OFF
function. Default setting = auto off after 4
minutes unused. Follow the below steps to
disable/employ the AUTO POWER OFF function.
a. Turn scale off
b. Press and hold NUMBER SET, then turn scale
on. Scale displays ¡F.1¡
c. Press NUMBER SET for three times. Scale
displays ¡F.4¡¨
d. Press @WT/SET to select:
To Next Page
Loading...
