Vacon 100 - COMMISSIONING

Modbus installation vacon • 10
24-hour support +358 (0)40 837 1150 • Email: vacon@vacon.com
4
4. MODBUS INSTALLATION
Figure 3.
1
Open the cover of the AC drive.
The relay outputs and other I/O-terminals may have a dangerous control voltage
present even when Vacon 100 is disconnected from mains.
2
Locate the components that you will need on the AC drive to connect and run the
Modbus cables.
Be sure not to plug the Modbus TCP cable to the terminal under the keypad! This
might harm your personal computer.
DANGER
WARNING