page 5 of 27
Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check carefully
the validity of this document with respect to his product. 25/11/2013 // 999281
ThismanualdescribespossibilitiestodecontaminatetheaspirationsystemsBVC
andthehandleVHC
pro
.
Priortodecontaminationcleanwithadampclothifnecessary.Usewateroramild
detergent as cleaning agent.
Prior to sending the devices to the factory the devices have to be decontami-
anted completely.
The applicability of the decontamination method and the selection of the ap-
propriate disinfectants have to be ensured by the user.
Ensure that repair is done only by an appropriately trained and supervised tech-
nician.Obeylocal andnationalsafetyrequirements.Ensurethatthetechnicianis
familiar with the safety procedures which relate to the products processed by the
pumpingsystem.Ensure that the pumpisdecontaminated before repair andthat
youtakeadequateprecautionstoprotectpeoplefromtheeffectsofhazardoussub-
stances if contamination has occurred.
+ Take adequate precautions to protect people from the effects of dangerous sub-
stances. Wear appropriate safety-clothing, do not inhale and avoid contact with
skin.
Prior to decontamination from outside and / or disassembling the device isolate
equipment from mains. Allowsufcientcooling.
Ensure that the device cannot be operated accidentally. Never operate the de-
vice if covers or other parts are disassembled. Never operate a defective or
damaged device.
Wait 5 seconds before starting work to allow the capacitors to discharge.
Beforestartingcheckthattherequiredparts(e.g.tools,disinfectnats)areavailable
and of the correct type.
Checktheoperatingsequencementallyusingexplodedviewdrawings,spareparts
lists and circuit diagram on feasibility, safety requirements and consequences on
safetyandfunctionoftheequipment.
Obeyregulationswhendisposingofsolventsandchemicals.
Inordertocomplywithlaw(occupational,healthandsafetyregulations,safetyat
worklawandregulationsforenvironmentalprotection)vacuumpumps,components
and measuring instruments returned to the manufacturer can be repaired only when
certainprocedures(seesection”Notes on return to the factory”)arefollowed.
Scrapping and waste disposal
Dispose of the pump and any components removed from it safely in accordance with
alllocalandnationalsafetyandenvironmentalrequirements.
Safety information!
NOTICE
NOTICE