VADDIO AV BRIDGE MATRIX PRO - Page 64

AV Bridge MATRIX PRO
AV Bridge Matrix Pro Manual - Document Number 342-0915 Rev C Page 64 of 68
System factory-reset
Sets or gets the factory reset status. An attempt will be made first to use the middleware. If that fails, clish will
revert to the old file I/O method. When the factory reset status is on, the system resets to factory defaults on
reboot.
Synopsis
system factory-reset {get | on | off}
Options
get
Get the current factory reset status.
on
Enable factory reset on reboot.
off
Disable factory reset on reboot.
Examples
system factory-reset get
Returns the factory reset status in this form:
factory-reset (software):
off
factory-reset (hardware):
off
----
system factory-reset on
Enables factory reset upon reboot. Returns current status in this form:
factory-reset (software):
on
factory-reset (hardware):
off
Trigger
Activate or deactivate a software trigger. This command is disabled if the trigger is in test mode.
Synopsis
trigger <1-10> {on | off} [block [seconds]]
Options
on
Turns on the specified trigger.
off
Turns off the specified trigger.
block
Block until all macros initiated by the state change have
finished. Optionally specify the number of seconds to wait for
the macros to run. If the block interval is not specified, the
default is 60 seconds.
Examples
trigger 2 on
Enables trigger 2.
trigger 3 off block 10
Turns off trigger 3, allowing up 10 seconds for macros to finish if any are running.
Sleep
Utilized as a pause command in Macros.
Synopsis
sleep <1-10,000mS>
Example
sleep 150
delays next command by 150 milliseconds
Version
Returns the current software version.
Synopsis
version
Example
AVBMP 1.0.0