VADDIO AV BRIDGE MATRIX PRO - Video and Streaming Commands

AV Bridge MATRIX PRO
AV Bridge Matrix Pro Manual - Document Number 342-0915 Rev C Page 58 of 68
Camera ccu scene
Set or recall a ccu scene for the specified camera.
Synopsis
camera ccu scene [1-3] {recall {factory [1-6] | custom [1-3]} | store custom [1-3]}
Required
[1 – 3]
Specify which camera’s ccu scene to work with.
Options
store custom [1 – 3]
Store a custom ccu scene.
recall {factory [1 – 6]
| custom [1 – 3]}
Recall a ccu scene. Specify one of the six factory preset
scenes or one of the three available custom scenes.
Examples
camera 3 ccu scene recall factory 2
Recalls factory preset scene 2 for camera 3.
camera 1 ccu scene store custom 1
Stores camera 1’s current ccu scene as its first custom ccu scene.
Camera standby
Set or change camera standby state.
Synopsis
camera standby [1-3] {on | off | toggle}
Required
[1 – 3]
Specify the camera to work with.
Options
on
Put the camera in standby mode.
off
Bring the camera out of standby mode.
toggle
Change the camera’s standby state.
Examples
camera 3 standby on
Puts camera 3 in standby mode.
camera 1 standby toggle
Changes camera 1’s standby state. If camera 1 was not in standby mode, it will go to
standby. If it was in standby already, it will come out standby.
Video and streaming commands
The base command video is used to control video behaviors such as PIP and program output source.
This section covers the video subcommands:
source
stream pip
mute
The MATRIX PRO uses only one form of the streaming base command - streaming settings get.
Video source
command description.
Synopsis
video <output> source [get | set] {input1 | input2 | input3 | input4}
Outputs
program
Applies the command to the Program output.
stream
Applies the command to the Stream output.
Options
set
Defines the source for the specified output.
get
Returns the current source for the specified output.
Sources
input1 through
input4
Specifies Input 1, 2, 3, or 4 as the source for the output.
stream
The Program output may be set to use the Stream output.
Examples
video program source get
Returns the current source for the video program output in the form
source: input1
video stream source set input2
Sets input 2 as the source for the video stream output.
video program source set stream
Sets the stream output to provide the program output as well.