AV Bridge
Vaddio AV Bridge - Document Number 342-0518 Rev C Page 10 of 36
System Configuration and Programming:
Front Panel Menu
The front panel menu system allows some basic configuration of the AV Bridge and serves to display the
important system parameters and settings. The menu tree is depicted below:
> Start Page: Initializing and Audio Ladder Appear
> Main Menu
> Audio Inputs (Selectable from front panel)
> Balanced (Low Z)
> Unbalanced (High Z)
> Video Inputs (Selectable from front panel if connected to video source only)
> Auto
> HD YPbPr
> HD RGBHV
> HDMI
>SD
> Streaming (Streaming type is not selectable from front panel)
> USB Streaming (Shown if set to USB Streaming is selected using the internal web pages)
> IP Streaming (Shown if set to IP Streaming is selected using the internal web pages)
Resolution (i.e. 720p)
Quality (i.e. High Quality, Standard, Low bandwidth)
>Network Configuration (read only)
>Host Name
> Network Settings (read only)
> Mac Address:
> IP Address:
> Subnet Mask:
> IP Gateway:
>Type: DHCP
> Version
> 1.2.0
Selecting Audio & Video Input Sources:
Video Input Selection: This allows the user to select between Auto-Detection, HDMI, HD, or SD video inputs.
These selections correspond to the connectors on the back panel of the AV Bridge. The HD connector (DE-15)
will support signal formats of up to 1080p/60 on either YPbPr or RGBHV inputs. The HDMI connector only
accepts HDMI and DVI signals up to 1080p/60. The SD signals are 480i/NTSC and 576i/PAL.
Please see the
Video Inputs & Supported Video Resolutions section in the General Specifications
Audio Input Selection:
The user has the ability to select between the balanced stereo audio input and an unbalanced stereo input.
To Next Page
Loading...
