4 Set-up
28 Installation instructions electronicVED 0020288452_00
– Water inlet temperature
– Water outlet volume
– Performance category of the product
If the set domestic hot water temperature
is not reached, reduce the water volume.
3.3 Information on the data plate
Symbol Meaning
The VDE GS mark
confirms that the unit
complies with stand-
ards and has been
tested for safety.
Symbol confirming
conformity with the
electromagnetic com-
patibility standard
Read all of the in-
structions.
Barcode with serial
number,
The 7th to 16th digits
of the serial number
form the article num-
ber
3.4 CE marking
The CE marking shows that the products
comply with the basic requirements of the
applicable directives as stated on the de-
claration of conformity.
The declaration of conformity can be
viewed at the manufacturer's site.
4 Set-up
4.1 Checking the scope of delivery
Quantity Designation
1 Product
1
Operating and installation in-
structions
1
Bag containing fixing material
(2 bolts, 2 wall plugs, 3 seals, 1
special fixing screw)
1 G 1/2" cold water connector
with a cold-water isolation valve
1 G 1/2" domestic hot water con-
nector
2 Double nipple
1 12 l/min flow rate limiter
1 Strainer for the cold water inlet
1 Mounting plate
1 Mounting template
4.2 Selecting an installation
location
▶ Install the product as close as possible
to the draw-off points that are used
most frequently.
Note
The product may also be in-
stalled above baths or in a
shower area.
To Next Page
Loading...
Need help?
General