USER’S GUIDE_______________________________________________________________________
6 ______________________________________________________________________U376EN-1.1
CHAPTER 3
INSTALLATION AND MAINTENANCE
Mounting
Mount the wall model transmitter or the remote probe into a place,
which gives a true picture of the environment to be measured and is as
clean as possible. Air should circulate freely around the probe. Please
take into a consideration that because CO
2
is slightly heavier than air
it tends to accumulate in low areas without proper ventilation e.g. the
CO
2
concentration is higher there.
Figure 4 Mounting the transmitter
$WWDFKWKHPRXQWLQJ
SODWHWRWKHZDOOZLWK
VFUHZV
3UHVVGRZQWKH
WUDQVPLWWHUVRWKDWLW
VOLGHVDORQJWKHUDLOV
RIWKHPRXQWLQJSODWH
To Next Page
Loading...
