Need help?Do you have a question about the Vaisala DMT152 and is the answer not in the manual?
General| Measurement Range, Humidity | 0 to 100 %RH |
|---|---|
| Output Signal | 0 to 1 V, 0 to 10 V, 4 to 20 mA |
| IP Rating | IP65 |
| Accuracy, Temperature | ±0.2 °C |
| Operating Temperature | -40 to +60 °C |
| Storage Temperature | -40 to +70 °C |
| Measurement Range, Temperature | -40 ... +60 °C |
| Power Supply | 10 to 35 VDC |
| Housing Material | Plastic (PC-ABS) |
Covers safety precautions, electrostatic discharge protection, and disposal instructions.
Describes the patented technology ensuring accuracy, stability, and low maintenance.
Explains the automatic procedure to reduce dewpoint measurement drift.
Details the automatic procedure to minimize drift at the wet end readings.
Step-by-step instructions for physically installing the DMT152 unit.
Connecting to PC via serial/USB, driver installation, and terminal settings.
Setting up analog outputs, alarms, and scaling for measurement signals.
Settings for serial interface, response time, address, output format, units, and mode.
Enabling/disabling sensor purge and setting pressure/molar mass for calculations.
Information on factory calibration, recommended intervals, and field checking.
Overview of common issues, causes, and initial troubleshooting steps.
Details on dewpoint temperature and ppm measurement ranges and accuracies.
To Next Page