Vaisala DMT152 - Other Commands; Opening the Transmitter in POLL Mode; Closing the Connection to a Transmitter in POLL Mode; Display Command List

User's Guide _______________________________________________________________________
52 ___________________________________________________________________ M210865EN-H
Other Commands
Opening the Transmitter in POLL Mode
Use the OPEN command to connect to a transmitter that is in POLL
mode.
OPEN [aa]<cr>
where
aa
=
address (0 ... 99)
Example:
open 1
DMT152 1 line opened for operator commands
Closing the Connection to a Transmitter
in POLL Mode
The CLOSE command closes the connection to a transmitter.
CLOSE<cr>
Example:
close
line closed
Display Command List
HELP<cr>
Set Time
Use the TIME command to view and set the transmitter clock. The clock
does not have a battery backup – it is reset to 00:00:00 when the
transmitter is powered up or reset.
TIME [hh mm ss]<cr>
where
hh
=
Hours (24-hour clock)
mm
=
Minutes
ss
=
Seconds